Quay Concrete              

Contact with wet cementious mixes (such as mixed concrete and screeds) can cause serious burns and diseases. It is your responsibility to ensure that all staff / people who may come in contact with the mix are made aware of these hazards and that the correct protective clothing, footwear, and eye protection is used.

Direct contact with the skin by wet concrete should be avoided. The eyes are particularly vulnerable and damage will increase with contact time.

When working with or laying concrete the following safety measures must be observed.

• Wear protective clothing , hard hat, googles, gloves and wellingtons
• Avoid direct contact with the wet concrete with the skin or eyes
• Should you come in to contact with wet concrete you must wash and rinse immeadiately with water                                               

Fiber reinforced concrete (FRC) is concrete containing fibrous material which increases its structural integrity. It contains short discrete fibers that are uniformly distributed and randomly oriented. 

Reduced water absorption is a function of the fibres ability to reduce plastic shrinkage cracking, reducing the ability of water to permeate into the bleed in a concrete. Reducing another possible entry by water into the concrete in its hardened state.
Introduction of fibres improves the toughness of the concrete, with improvements in impact and abrasion resistance. Coupled with the above, helps make the concrete less susceptible to freeze thaw damage.
 

Dosage and Performance

Fibrillated fibres are introduced into the concrete mix at a rate of 0.9kg/mþ. No adjustment to the mix design is required. Fibre reinforced concrete requires no special precautions and can be power floated, pumped and trowelled like other concretes.
Note: Fibres are not a substitute for structural steel reinforcement.
 

Admixtures

Admixtures are added to concrete during mixing to alter its properties, such as workability, curing temperature range, set time or color.

They fall into the following catorgies each with its own benifits and uses :

• Retarding admixtures
• Accelerating admixtures
• Super plasticizers
• Water reducing admixtures
• Air-entraining admixtures

Retarding admixtures

Retarding admixtures slow down the hydration of cement, lengthening set time. You ise retarders mainly in hot wather, or where a large pour is been done and and the workability and setting time needs to be maintained.

Retarders are commonly used in floor screeds, giving increase workability over long periods

Accelerating admixtures

Accelerators shorten the set time of concrete, allowing a cold-weather pour, early removal of forms, early surface finishing, and in some cases, early load application. Proper care must be taken while choosing the type and proportion of accelerators, as under most conditions, commonly used accelerators cause an increase in the drying shrinkage of concrete.

Super plasticizers

Super plasticizers, also known as plasticizers, include water-reducing admixtures. They can maintain a specific consistency and workability at a greatly reduced amount of water.  They can also produce a high strength concrete.

Water reducing admixtures

Water reducing admixtures require less water to make a concrete of equal slump, or increase the slump of concrete at the same water content. They can have the side effect of changing initial set time. Water reducers are mostly used for hot weather concrete placing and to aid pumping.

Air-entraining admixtures

Air-entraining agents entrain small air bubbles in the concrete. The major benefit of this is enhanced durability in freeze-thaw cycles, especially relevant in cold climates. While some strength loss typically accompanies increased air in concrete, it generally can be overcome by reducing the water-cement ratio via improved workability (due to the air-entraining agent itself) or through the use of other appropriate admixtures.